Step 1 Dig, rasp, or drill the inside of the nose using good reference. Shown here is a rasp working behind the wing area.

Step 2 It is not mandatory, but you may totally remove the septum wall, making it easier to clean out.

Step 3 By rocking the tool on the nose pad area, it will cut into the form. Once through, use your thumb to push the septum tool straight back into the form.

Step 4 While curling the septum with your fingers, insert it into the previously cut track, veins inward. If the Speed Septum seems stiff and not easy to curl, warm it up to improve its flexibility.

Step 5 Once inserted, trim off the excess with a scalpel. Make sure there is not any septum edge protruding beyond the edge of the nose pad. Repeat the above steps for the other side of the nose.

Step 6 Mount the deer as usual. Cut the inner nose end skin smooth and run it up to or slightly overlap the septum.