How to Use the Shed Connection
The Shed Connection comes preassembled. In order to fasten the "hub" onto the antler, first unbolt the hub from the device.
Step 1 Secure the antler in a vise, making sure the antler is protected (a scrap piece of carpet will do). With a felt pen, mark the center of the antler base. Next, drill a 5/16" hole, 3/8" deep, into your center mark. Make sure that your hole is drilled perpendicular to the base.
Step 2 Drill the holes for the screws with a 1/8" drill bit to a depth of 1/2". The holes need to be drilled at an inward angle, towards the center of the antler. Before drilling all 4 holes, it is recommended to first drill only one hole and put that screw in to achieve proper alignment.
Shoulder and Antler Mounts
For shoulder or antler mounts where the Shed Connection is permanently covered, the entire device must be completely encased with a fiberglass reinforced filler (eg. Bondo-Glass). This will ensure that all the moving parts stay put as well as making the antlers more rigid.
![]()
![]()
Mailing Address: P. O. Box 480, Granite Quarry, NC 28072
Shipping Address: 1910 St. Luke's Church Road, Salisbury, NC 28186
Sales (US & Canada): (800) 279-7985,
Office: (704) 279-7985, Fax: (704) 279-8958
©1998-2012 WASCO Manufacturing, Inc. All Rights Reserved. This page last updated 01/13/12.